Diamond wedding ring sets

When looking for diamond wedding ring sets it is customary for people to think in terms of matching an engagement ring with a wedding band. Some people however, may decide they would like to design their own wedding ring sets. . In this case, there is an inexhaustible selection of designs to be created. This process of designing your diamond wedding ring sets can be an extremely rewarding and emotional process.

The engagement ring is usually viewed as being one part of a set. The complete set would include the engagement ring and the wedding band. Two rings can either be matching or simply complement one another. Since the engagement ring usually contains a center diamond the diamond wedding ring sets will never completely match. Often they consist of similar lines, and the same number of accent stones whenever that is the case.

Buying diamond wedding ring sets together

Frequently your diamond wedding ring sets are bought at the same time. If it is not bought at the same time then people have to anticipate what type of wedding band people will have at a later date because this could have a bearing on the selection of the engagement ring.

It is useful to keep in mind how it will change the appearance of the engagement ring. If someone chooses a wide engagement ring like 5mm that looks nice on the finger by itself. It could end up being much too wide when a matching wedding band is added. This would make a 10mm wide ring. A ring can become uncomfortable to wear at that point. This is particularly the case if the person should subsequently decide to have more than one wedding band. For example: sometimes people decide to have matching wedding bands that fit on both side of the engagement ring. However, you may want to taper them more on the bottom of the shank so as to appear wider on top of the finger but, have a more comfortable ring width under your ring finger.

Another reason for having some idea about what kind of wedding band to have gone with the engagement ring is that the overall width of the two rings has an effect on the appearance of the center diamond in the engagement ring. A diamond of a particular weight may look appropriate on a particular width wedding band but then appear to be overwhelmed when the wedding band or bands are added. For example a 3mm engagement ring, and 3mm band equals 6mm. This is approximately the same width as a 1 carat diamond. This would be a nice balance because the bands would not be larger than the diamond.

Sets that compliment rather than match

It is probably more common for the diamond wedding ring sets to be complimentary rather than matching. For example: A wedding band in addition to having a center diamond can have a row or rows of smaller accent diamonds. The wedding band that goes with it may not need to have any accent diamonds at all. In fact, the reverse is perhaps more often the case where the wedding band has the accent diamonds. And the diamond consists mainly of the center set stone.

When the engagement and wedding band contains smaller accent diamonds they are usually constructed in rows that are referred to as channel settings. Most often this prescribes the shapes of the diamonds and usually limits those shapes to rounds and princess cuts. A more recent innovation that seeks to separate the accent diamonds one from the other is to burnish them in the band. Either randomly or at spaced intervals.

One should not overlook the unique look that can be obtained by using colored precious stones as accents in diamond wedding ring sets. Another variation is to use a precious colored stone as the solitaire in the engagement ring and compliment its look with diamond accent stones. This is not done frequently but does create a very desirable and individual look when it is done deliberately and with good design.

Although it is usually the case, it is not absolutely necessary that in the case where gold is being used in your ring sets that you use the same color in both rings. You may choose to have yellow gold in one and white gold in the other.

It is common for one to solder the diamond wedding ring sets together after they couple is married. Whether or not one anticipates soldering the rings together can have a bearing on wedding band selection in some cases. An example of this would be: a wedding band that has a row of diamonds placed in it. When one knows ahead of time whether they intend to solder the rings together they won’t be as concerned about the length of the channel as they might otherwise be. Because when the rings are soldered together the wedding band will not spin on the finger, and the channel will always be positioned properly on the finger.

If you have further questions, please feel free to call us at the number below.